Before Using The Appliance For The First Time; Electrical Connections - Bosch KDN Series Instructions For Installation And Use Manual

Before using the appliance for the first time

Take out the information material and remove the
1.
adhesive tape and protective foil.
Clean the appliance.
2.
"Cleaning" on page 14

Electrical connections

Caution!
Do not connect the appliance to electronic
energy-saving power sockets.
You can connect the appliance to phase or
Note:
sine-wave commutated power inverters.
Phase-commutated inverters are used with photovoltaic
systems that have a direct connection to the mains
power grid. With standalone set-ups, you must use
sine-wave commutated power inverters. Standalone
set-ups, e.g. on ships or in mountain huts, do not have a
direct connection to the mains power grid.
After setting up the appliance wait at least 1 hour
1.
before connecting it in order to avoid damage to the
compressor.
Connect the appliance to correctly installed power
2.
outlet socket.
The power outlet socket must match the following
specifications:
Power outlet socket with 220V ... 240 V
Protective earth
Fuse
Outside Europe: check whether the specified power
rating of the appliance matches your power supply.
Details of the appliance rating can be found on the
rating plate.
"Getting to know the appliance" on page 8
Connect the appliance to a power socket close to the
3.
appliance.
The power outlet socket must also remain easily
accessible after the appliance has been installed.
50 Hz
10A ... 16 A
Setting up and connecting the appliance
en
7