Vad (Voice Activation Detection) - Transcend MP840 User Manual

2. Push the "Menu Switch" down (Next)
Record Quality settings: Low – Middle – High. Press the "Menu Switch" inwards (MENU)
select the Record Quality level and return to the SETTINGS Menu.
Record Sound
If not enough memory space is available, or the battery power is too low, the MP840 cannot support
the maximum recording capacity as outlined in the above table.
The closer you move the MP840's Microphone to the source of the sound the higher the quality of the
recording.
RADIO Recordings are recorded in Stereo. MIC Recordings are recorded in Mono.

VAD (Voice Activation Detection)

VAD allows the MP840 to make gapless audio recordings. This means the player will only begin recording
when it detects the subject is speaking, if the person(s) pauses, or stops speaking the MP840 will stop
recording until the person(s) starts speaking again. This allows you to make complete and very easy to
listen to recordings.
1. In the SETTINGS Menu, push the "Menu Switch" down (Next)
select the VAD item, then press the "Menu Switch" inwards (MENU)
Sample rate
Low (8KHz) 1 (stereo/mono)
Middle (16KHz) 1 (stereo/mono)
High (32KHz) 1 (stereo/mono)
or up (Previous)
Channels
64/128 hrs
32/64 hrs
16/32 hrs
to switch between the 3
2GB 4GB
128/256 hrs
64/128 hrs
32/64 hrs
or up (Previous)
to enter the VAD Mode.
to
to