Transcend 630 User Manual page 59

Cannot hear track playback
1. Have you downloaded any music files onto the T.sonic
computer or the Internet. (Only Mpeg I Layer 3 and WMA files compressed at a rate of
32Kbps–320Kbps are supported.)
2. Are the earphones properly connected to the earphones jack? If not, reconnect them.
3. Is the volume loud enough? If not, increase the volume level until the music can be heard.
Track name does NOT display correctly on the screen
1. The default language of the T.sonic
2. ID3 tag information has display priority on the screen of the T.sonic
using Windows Media Player or Winamp.
3. If the ID3 tag is empty, just the file name will be displayed on the screen.
Cannot enter the RECORD Mode
To make sure the recorded file will not be lost, two safety mechanisms are provided.
1. If the remaining battery capacity is less than 10%, you cannot enter the RECORD Mode.
2. During recording, if the remaining battery capacity goes below 10% the T.sonic
save the recording.
Track playback sounds intermittent
Plug the earphones into the earphones jack again to make sure they are properly connected.
™
T.sonic Powers OFF automatically
™ features a SLEEP Mode , which acts as a Power Saving feature. You can preset your T.sonic
T.sonic
to Power OFF automatically after 15, 30, or 60 minutes. Please refer to the "
™
T.sonic just isn't working properly
If your T.sonic ™ ever stops working properly, or locks up, try Powering it ON and OFF a few times, if this
does not correct the problem you can Reset the unit by pressing the "Reset" button
seconds. If all of these options fail you can restore your T.sonic
the "
Recovery Function
Cannot find the file that was just copied to the T.sonic
Re-copy the file and refer to the "
the copy process is completed.
A File that was just deleted still appears
Re-delete the file and refer to the "
after the delete process is completed.
™
T.sonic automatically removed from the operating system
This problem occurs when you press the "Volume Down" button
connected to a Computer USB port. Unplug your T.sonic
™ is English. Please set the language option first.
."
Disconnecting from a Computer
Disconnecting from a Computer
™ ? If no, then you must first do so from your
™ . You could modify the ID3 tag by
Sleep
™ to its Default Factory Settings by using
™
" section to remove the T.sonic
" section to remove the T.sonic
while your T.sonic
™ from the USB port and plug it back in again.
55
™ will automatically
™
" section in SETTINGS .
for 3 to 5
™ after
™
™ is still