Table of Contents
Advertisement
If an error occurs with your T.sonic, please first check the information listed below before taking
your T.sonic for repair. If you are unable to remedy a problem from the following hints, please
consult your dealer, service center, or local Transcend branch office. We also have a FAQ and
Support on our websites.
Driver CD cannot auto-run in Windows
Enter Device Manager in the Control Panel and enable the Auto-Insert function of the CD-ROM
drive. Alternatively, you can manually execute the T.sonic.EXE from the driver CD.
Operating system cannot detect the T.sonic
Check the following:
1. Is your T.sonic properly connected to the USB port? If not, unplug it and plug it in again.
2. Is your T.sonic connected to the Mac keyboard? If yes, unplug it and plug it into an available
USB port on your Mac Desktop instead.
3. Is the USB port enabled? If not, refer to the user's manual of your computer (or motherboard)
to enable it.
4. Is the necessary driver installed? If your computer is using Windows
the Driver CD into the CD-ROM and refer to the "Driver Installation for Windows
section to complete the driver installation before using your T.sonic. A driver is not required for
Win
ME/2000/XP, Mac OS 9.0 or later, or Linux Kernel 2.4 or later.
5. Is there a battery in the T.sonic? If yes, remove the battery and plug it into the port again.
Cannot power on
Check the following:
1. Is the T.sonic connected to your computer? If yes, unplug it.
2. Is the battery inserted correctly? If not, reverse the battery direction.
3. Is the battery power used up? If yes, replace it with a new one.
Cannot download MP3 or WMA files to the T.sonic
As required, uninstall the driver and re-install it. If this doesn't work, see the Recovering Your
T.sonic Chapter to format your T.sonic.
Buttons don't work
Troubleshooting
34
98SE, you must insert
98SE"
Advertisement
Table of Contents
