Table of Contents
Advertisement
Cleaning and maintenance
en
Carefully unscrew the pump cover,
6.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
7.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash, pour 1 litre of
water (without detergent) into
compartment II and start the 0 Spin
programme. Do the next wash as usual.
The drain hose at the siphon
is blocked
Switch off the appliance.
1.
Disconnect the mains plug.
2.
Loosen the hose clamp. Carefully
3.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
4.
connecting piece.
34
Reattach the drain hose and secure
5.
the connection using the hose
clamp.
Filter in the water supply is
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any program (except 0 Spin).
2.
Press the A Start/Reload button.
3.
Allow the program to run for
approximately 40 seconds.
Turn the program selector to off
4.
position.
Pull out the mains plug.
5.
Clean the filter on the tap:
6.
Disconnect the hose from the tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
7.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Insert the filter, connect the hose and
8.
check for leaks.
Advertisement
Table of Contents
