Table of Contents
Advertisement
Programme end during rinse
hold
0 - - - - appears in the display panel and
the indicator lamp of the A Start/
Reload button flashes.
Continue the program by:
Pressing the A Start/Reload button
■
(the laundry will be drained with the
default spin speed setting*) or
Selecting a spin speed or set the
■
program selector to 0 Spin and then
pressing the A Start/Reload button.
* depending on the chosen program ->
Overview of programmes
Programme end
End appears in the display panel and
the indicator lamp of the A Start/
Reload button is off.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Turn the programme selector to Ú
2.
Off. Appliance is switched off.
Turn off the tap.
3.
Not required for Aqua-Stop models.
Contents of package
Notes
– Do not leave any items of laundry
in the drum. They may shrink in
the next wash or discolour
another item.
– Remove any foreign objects from
the drum and the rubber seal –
risk of rusting.
Setting the signal
– Leave the washing machine door
and detergent drawer open so
that any residual water can dry
away.
– Always remove the washing.
– Always wait until the programme
ends, as the appliance could still
be locked. Switch the appliance
on and wait for the unlocking
device.
– If at the end of the programme
the display has gone out, the
energy saving mode is active. To
activate, select any button.
M
Setting the signal
Y ou can change the following settings:
S e t t i n g t h e s i g n a l
The volume for the information
■
signals (e.g. at the end of the
program) and/or
The volume of the audible button
■
signals.
You will need to activate the setting
mode in order to change these settings.
1/2/3/...
positions on the program
selector
Activate setting mode:
Set the program selector to
1.
position 1. The washing machine is
switched on.
Press the A Start/Reload button
2.
and, at the same time, turn the
program selector clockwise to
position 2.Release the button.
en
31
Advertisement
Table of Contents
