Disconnect Device; Installation; Fuse Replacement; Dmx Connection - AFX SPOT100-LED User Manual

Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The appliance must be replaced if it is damaged or thermally deformed.
• The LED protection screen must be replaced if it is visibly damaged to the point of impairing its
effectiveness, for example due to cracks or deep scratches.
• The light source of this luminaire is not replaceable; when the light source reaches the end of its
life, the entire luminaire must be replaced.

DISCONNECT DEVICE

Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.

INSTALLATION

This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique moun-
ting bracket assembly that integrates the bottom
of the base, the included 'omega bracket' and the
safety cable rigging point in one unit (see the illus-
tration on the right). When mounting this fixture
on a truss, be sure to use an appropriate clamp
with the included omega bracket using a M10
screw fitted through the center hole of the 'ome-
ga bracket'. As an added safety measure, be sure
to attach at least one properly rated safety cable
to the fixture using one of the safety cable rigging
points integrated in the base assembly.

FUSE REPLACEMENT

• Disconnect the power cord before replacing a
fuse and always replace with the same type fuse.
• Turn the fuse knob to access the fuse.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
• Close the fuse compartment and reconnect power.

DMX CONNECTION

Connect an XLR cable to the male 3-pin XLR output of your controller and the other side to the fe-
male 3-pin XLR input of the light.You will need a serial data link to run light shows of one or more
fixtures using a DMX-512 controller or to run synchronized shows on two or more fixtures set to a
master/slave operating mode. The combined number of channels required by all fixtures on a serial
data link determines the number of fixtures that the data link can support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum re-
commended serial data link distance: 100 meters (328ft.) Maximum recommended number of fix-
tures on a serial data link: 11 fixtures
The cable needed should be two core, screened cable with XLR input and output connectors.
www.afx-light.com
3 EN