Battery - BMW R 1200 R Rider's Manual

battery from the on-board
7
electrical system.
Remove the protective cap
120
from the battery's positive
terminal 1.
Run the engine of the donor
vehicle during jump-starting.
Begin by connecting one
end of the red jump lead
to the positive terminal of
the discharged battery and
the other end to the pos-
itive terminal of the donor

battery.

z
Then connect one end of
the black jump lead to the
negative terminal of the
donor battery, and the other
end to negative terminal 2 of
the discharged battery.
Start the engine of the
vehicle with the discharged
battery in the usual way; if
the engine does not start,
wait a few minutes before
repeating the attempt
in order to protect the
starter motor and the donor

battery.

Allow both engines to idle
for a few minutes before
disconnecting the jump
leads.
Disconnect the jump lead
from the negative termin-
als 2 first, then disconnect
the second jump lead from
the positive terminals 1.
Reinstall the protective cap
on battery positive termin-
al 1.
Do not use proprietary
start-assist sprays or
other products to start the
engine.
Install the seat (
Battery
Maintenance instructions
Correct upkeep, recharging
and storage will prolong the
life of the battery and are es-
sential if warranty claims are
to be considered.
Compliance with the points
below is important in order to
maximise battery life:
Keep the surface of the bat-
tery clean and dry
Do not open the battery
Do not top up with water
Be sure to read and com-
ply with the instructions for
charging the battery on the
following pages
Do not turn the battery up-
side down
57)
If the battery is not dis-
connected, the on-board
electronics (e.g. clock, etc.)
gradually drain the battery.