Advertisement
Available languages
Available languages
2. Delivery / Scope of delivery
After receipt of the goods please check whether the delivery is complete and whether the items are intact.
The delivery consists of one reel AQUALUC including a connection cable.
3. Area of application
Examples for applications of the AQUALUC:
• accent illumination
• architectural illumination
• shipbuilding
• stairway illumination
4. Technical data [extract]
AQUALUC 14
AQUALUC 25
24 W | 12 W
26 W | 13 W
2,700 K | 3,200 K | 4,600 K | 6,500 K 3,500 K | 4,400 K | 6,400 K | 9,000 K
14 mm
Detailed technical information can be found in the relevant data sheet at www.barthelme.de
5. Installation and commissioning
5.1 Installation and processing guidelines
• The processing temperature range of the AQUALUC is between 15°C and 35°C. Temperatures below
this can negatively influence the flexibility of the stripe and can result in damage. If the AQUALUC was
previously exposed to lower or higher temperatures, then it must be slowly brought into the processing
temperature range.
• Please note that the AQUALUC can marginally expand or contract with changes in temperature at the
installation location. This is not a defect in the product but a normal physical process. Specifically, this
means that there is a linear thermal expansion of approx. 1 mm per meter and 15 °C change in tempe-
rature. This extra expansion gap should always be taken into consideration prior to installation.
• To avoid damaging the AQUALUC, especially during unrolling or mounting, it is important that two people
install the product. This is especially valid for a length of one meter (1 m) or more. Care should be taken
that the product does not sag otherwise irrevocable damage can occur (see illustration 1). Furthermore,
the encapsulation of the product may not be damaged otherwise a sufficient protection of the LED stripe
cannot be ensured. It is important to never exceed the minimum bending radius!
• The minimum bending radius of the AQUALUC is 5 cm (ATTENTION: the minimum bending radius for
AQUALUC 25 HP is 9 cm!). The minimum bending radius may not be exceeded and the stripe may not be
bent, otherwise the AQUALUC could be damaged (see illustration 2).
• The product is suitable for installation on the floor, wall or ceiling - indoors and outdoors. Make sure that the
product is mounted on a clean, flat and stable surface.
• Depending on the surface and the application, the installation can be performed with the retaining bracket
(Art. 40100100), with thermal conductive double-sided adhesive tape (Art. 30033009) or with construction
adhesive (Art. 63500030).
AQUALUC 25 HP
24 V DC
Outdoor IP67/68
25 mm
13.5 x 6 mm
• illumination for outdoor, wellness, spa and pool areas
• backlight for illumination of letters
• exhibition lighting
• illumination for bars, and many more
64 W
25 mm
AQUALUC 33
operating voltage
protection class
48 W | 24 W
typical power
RGB
colour temperatures
33 mm
LED pitch
dimensions
width x height
Advertisement
