Table of Contents
Advertisement
Quick Links
Ferrari 360 Map Carbon Light Installation Instructions
Tools Required
4MM Allen Wrench
Small Philips Screw Driver
MAcarbon Chisel Install Tool
Detail Cloth
Detail Spray
Installation Steps
Step
Instructions
1.
Pop the map light out from the housing by inserting
the chisel tool into the gap on the light's right side.
Support the map light and let it hang.
2.
Photo
Advertisement
Table of Contents
Related Manuals for MAcarbon Ferrari 360 Map Carbon Light
Summary of Contents for MAcarbon Ferrari 360 Map Carbon Light
- Page 1 Ferrari 360 Map Carbon Light Installation Instructions Tools Required 4MM Allen Wrench Small Philips Screw Driver MAcarbon Chisel Install Tool Detail Cloth Detail Spray Installation Steps Step Instructions Photo Pop the map light out from the housing by inserting the chisel tool into the gap on the light's right side.
- Page 2 Step Instructions Photo Locate the four (!) Allen screws that mold the map light housing in the roof. Unscrew the housing from the roof. Lower the housing. Gently pull the wiring from the headliner. Undo the electrical connector.
- Page 3 Step Instructions Photo Place the map light on the workbench, carefully remove the two Phillips head screws which hold the clock in place. Disconnect the clock. Take this opportunity to clean all components of dust and grime. Install the clock and light in the CF housing. Be sure to route the wires correctly.
- Page 4 Step Instructions Photo Screw the unit into the ceiling. Push the light into place Admire your work!
Need help?
Do you have a question about the Ferrari 360 Map Carbon Light and is the answer not in the manual?
Questions and answers