Jumper Settings - PEP PB-SIO4 Manual

PB-SIO4

3.3 Jumper Settings

The jumper positions B1 to B6 are located on the front side of the PB-SIO4. They are
set at the factory as required and should not be changed.
$ $
Note!
Jumpers B1 through B6 are zero-Ohm resisters.
Before operating the PB-SIO4 ensure that the jumper settings are
set correctly according to the application. No external VCC may be
applied to the non-optocoupler version, and, correspondingly,
external VCC must be applied to optocoupler versions.
Table 3-1: Jumpers B1 to B6: Settings According to Version
B1 B2
closed closed
open open
Page 3 - 4
JUMPERS
B3 B4 B5
closed closed open
open open closed
® PEP Modular Computers GmbH
Configuration
VERSION
B6
open Non-Optocoupler
closed Optocoupler
ID 19957, Rev. 0300