Minelab GO-FIND Series Instruction Sheet page 2

SET UP
STEP 1. Your GO-FIND detector requires no
assembly or tools. Simply remove the detector from
the box.
Remove unlock caution tape
STEP 2. Press down the red UNLOCK button on both
sides to release the handle.
Failure to press the unlock button when
releasing handle will cause damage.
STEP 3. Insert 4 x 1.5V AA (LR6) batteries
(not included).
4 x AA
STEP 4. Slide out the armrest to desired length
(typically just under your elbow).
STEP 5. Fold out the search coil to detect parallel
with the ground (refer to Detecting Basics).
Tighten the wing nut to fix the coil position. Be
careful not to over tighten.
STEP 6. Fully extend the lower shaft and CLICK
into place (or leave collapsed for shorter detector
length). Refer to 'Detecting Basics' for adjusting to
correct length.
To retract shaft, firmly tap on the base of the coil.
STEP 7. Release the camlock lever to adjust the
upper shaft to desired length, for your height.
STEP 8. Adjust the armrest strap to securely fit
around your arm.
ACCESSORIES INCLUDED
(supplied with GO‑FIND 60 model only)
Ear buds | Digging tool | Phone holder
WARNING: This device contains
moving parts. Use caution when
adjusting components.
DO NOT lean on detector when
in use as it is not designed to
support your weight.