Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DIGISYNTHETIC K5
Summary of Contents for DIGISYNTHETIC K5
-
Page 2: Product Use Guide
Digital Karaoke Processor MIC VOL EFF VOL MUS VOL EDIT User Presets Effect Music Main Center Subwoofer Product use guide For more product information, please refer to the contents of disc with this device. - Page 3 IMPORTANT SAFETY INSTRUCTION e) The product has been dropped or the enclosure damaged.. 13. Do not attempt to service the product beyond that described in the Please read the basic protective measure as below before using. user-maintenance instructions. 1. Please read all the safety instruction before using the product. All other servicing should be referred to qualified service personnel.
-
Page 4: System Connection Diagram
Rear panelprofile WARNING: SHOCK HAZARD - DO NOT OPEN MA DE IN CHI NA IR REMOTE 2 microphone input (A3 and B2) Jacks Mains input Infrared remote port RS232C real-time PC control interface S/PDIF optical input interface S/PDIF coaxial input interface Right channel of main output Synchronous video output interface Left channel of main output... -
Page 5: Product Features
Product features 2. Twist the knob [EDIT] to adjust parameters. 3. Press key [ ] and [ ] to change the cursor's position of same This product is the use of 32-bit high performance DSP and page, to adjust various parameters. AD/DA, 48kHz sampling rate of professional digital multi- 4. -
Page 6: Effect Menu
separately): Frequency of Low-cut filter: 19.7Hz – 202Hz Off, or -90dB to 42dB, step 1dB Frequency of High-cut filter: 12100Hz - 20200Hz (8) Linking group A and B microphone Roll-off of filters: 12dB, 18dB, 24dB, 36dB Yes / No Type of filters: Bessel, Butterworth, Linkwitz-Riley (9) Feedback inhibition of microphone: (4) Volume of main output matrixes (channel L and R can be adjusted separately):... - Page 7 Gain: -15dB to +12dB, step 0.1dB (4) Press key [ ] to cancel, key [ ] to confirm. Bandwidth: 0.011 to 3.595 2. Preset recall (3) Low-cut and High-cut filters of subwoofer output: There are two ways to recall the user preset Frequency of Low-cut filter: 19.7Hz –...
-
Page 8: Restore To Factory Settings
protection of the amplifier and speaker. Avoid destroy the sound field because setting the volume is too large. Remote code table For example: The code is hexadecimal, user code is When the microphone parameter is set to -10dB, then the upper CINEMA/KTV 82H. - Page 9 7. Please refer the important security matters content from the manual. Available online computer Ground ACPower Grounding 5. Please confirm that computer and device have been properly Available online interface connected.Launch the GUI application, click Button “Online” in Accessories the menu,and select“USB” or “COM” to connect the device, which depends on how you actually connected the interface.
-
Page 10: Microphone Part
Technical specification Music Part Flat,Original pitch 107dB(analog), 114dB(digital) THD+N Output 1Vrms @ 1 kHz 0.002%(analog), 0.001%(digital) Frequency Response Main / Center output 20Hz-20kHz±0.5dB Subwoofer output 20Hz-2000Hz ±0.5dB 4Vrms Maximum Input Level Analog input: BGM / IN1 / IN2 Digital input: Optical / Coaxial 0dBFS = 2Vrms Maximum Output Level 4Vrms... - Page 11 Signal Flow Graph NOISE GATE VOLUME 7 PEQS MIC VOL DIRECT SOUND PHASE INVERT DELAY VOLUME/PHASE MAIN-L HPF/LPF HPF/LPF COMPRESSOR 15 PEQS ECHO MIC-A IN EQ OPTIMIZE HPF/LPF COMPRESSOR 10 PEQS FB INHIBITION EFFECT VOL NOISE GATE REVERB MIC VOL VOLUME 7 PEQS HPF/LPF...