Pro-face PSB-CD/FD01 Installation Manual

The PSB-CD/FD01 CD-ROM/FD drive unit is made by Pro-face for use with its
PS-2000B Series Built-in computer (hereafter referred as the "PS-B") units.
Corresponding Product : PS-2000B Series Units
All product names used in this document are the trademarks of their respective
manufacturers.
Pro-face : Digital Electronics Corporation (in Japan and other countries)
• Be sure to check that the PS-B's power is disconnected before
installing the unit, in order to prevent an electrical shock.
• Do not attempt to modify or open the PSB-CD/FD01, since it can
cause a shock or fire.
• When installing the PSB-CD/FD01, be sure to read this guide's
"3. Installation" section's information completely to insure that the
unit is correctly installed.
To prevent this unit from malfunctioning :
• Since the PSB-CD/FD01 is a precision instrument, be sure that it is neither hit
by nor pressed strongly against another object.
• Be sure that water, liquids, or metal particles are not allowed to contact or
enter this unit. Any of these may cause either a breakdown or an electrical
shock.
• Do not place or store this unit in a location where there is direct sunlight,
excessive heat, dust or vibration.
• Do not store or operate this unit in a location where there is direct sunlight,
excessive heat, dust or vibration.
• Do not use the PSB-CD/FD01 in locations where corrosive gasses are
present.
• To prevent damage to file data, be sure to shut down the PS-B unit's OS
before turning OFF the main power.
PSB-CD/FD01
Installation Guide
WARNINGS
-1-