Pro-face PSS-CD01 Manual

The PSS-CD01 (CD-ROM Drive Unit) is the designed for use with Pro-face's
Compact Panel Computer PS-3701A(Eden
hereafter referred to as the "PS-A" and Panel Computer PL-X920/X930 Series,
hereafter referred to as the "PL". While the PSS-CD01 provides a convenient
way to install software into the PS-A/PL's HDD unit, it is not designed to be
used outside of the development environment.
Corresponding Products: PS-3701A(Eden
Pro-face is a trademark of Digital Electronics Corporation, registered in Japan and
other countries. All other trademarks/registered trademarks are the properties of their
respective owners.
! ! ! ! !
• Be sure to check that the PS-A/PL unit's power cord is disconnected before
installing this unit. Failure to do so may cause an electric shock.
• Do not attempt to modify or open the PSS-CD01. This may cause a fire or an
electric shock.
• Be sure to read the "2. Installation to PS-A" section or "3. Installation to PL"
section completely to insure that the PSS-CD01 is correctly installed.
To Prevent Accidents
• Since the PSS-CD01 is a precision instrument, be sure it is neither hit by nor
pressed strongly against another object.
• Be sure water, liquids or metal particles are not allowed to enter the PSS-
CD01's connector. Any of these may cause either a breakdown or an electric
shock.
• Do not store or operate this unit in a location where there is direct sunlight,
excessive heat, dust or vibration.
• Do not store or operate the PSS-CD01 near chemicals, or where there are
chemical fumes.
• Do not use the PSS-CD01 in locations where corrosive gases are present.
• To prevent damage to file data, be sure to shut down the PS-A/PL unit's OS
before turning OFF the main power.
Unit Disposal
• When the product is disposed of, it should be done so according to your
country's regulations for similar types of industrial waste.
PL-X920/X930 Series units.

Warning - Safety Precautions

Preface

TM
ESP6000 - 667MHz Model),
TM
ESP6000 - 667MHz Model), and
E-1