Pro-face PL-DK210 Installation Manual

Installation Guide
The PL-DK210 (CD-ROM Unit) is designed for use with Pro-face's PL
Series Panel Computers, hereafter referred to as the "PL". This unit is the
CD-ROM unit for the PL.While the PL-DK210 provides a convenient way
to install software into the PL's HDD unit, it is not designed to be used
outside of the development environment.
Corresponding Products: PL-X920 Series Units.
Pro-face is the trademark of Digital Electronics Corporation, registered in Japan
and other countries. MS-DOS is the trademark of Microsoft Corporation in the
United States and/or other countries. All other trademarks/registered trade-
marks are the properties of their respective owners.
Warning - Safety Precautions
• Be sure to check that the PL unit's power cord is disconnected before in-
stalling this unit. Failure to do so may cause an electric shock.
• Do not attempt to modify or open the PL-DK210 unit. This may cause a
fire or an electric shock.
• Be sure to read the "2. Installation" section completely to insure that the
PL-DK210 unit is correctly installed.
To Prevent Accidents
• Since the PL-DK210 is a precision instrument, be sure it is neither hit by
nor pressed strongly against another object.
• Be sure water, liquids or metal particles are not allowed to enter this unit's
connector. Any of these may cause either a breakdown or an electric
shock.
• Do not store or operate this unit in a location where there is direct sun-
light, excessive heat, dust or vibration.
• Do not store or operate this unit near chemicals, or where there are chemi-
cal fumes.
• Do not use the PL-DK210 in locations where corrosive gases are present.
• To prevent damage to file data, be sure to shut down the unit's OS before
turning OFF the main power.
PL-DK210
-1-