Biostar Z490GTA EVO User Manual page 13

Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion card into the
computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely seated in the
slot.
• Secure the card's metal bracket to the chassis back panel with a screw. (This step is only
for installing a VGA card.).
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
Note
» Please be note that you will need to use M2 type screwdriver if you want to install or uninstall the
screw. It is recommended not to use a screwdriver that does not meet the specifications, otherwise
the screw may be damaged.
Install M.2 COOLING Heatsink
Steps of Removing the M.2 COOLING Heatsink:
Step 1:
There are two screws on the edge
of heatsink and unscrew them
before insert the M.2 SSD card.
Note
» Please follow the installation instructions of M.2 COOLING Heatsink and remove the M.2 COOLING
Heatsink to install the M.2 SSD card onto your motherboard.
Step 2:
Insert M.2 SSD card onto the
M.2 slot and screw it onto the
motherboard.
Step 3:
After installing the M.2 SSD card,
place the M.2 COOLING Heatsink
over the M.2 slot and fasten the
screws to fix the heatsink onto
the motherboard.
Chapter 2: Hardware installation | 13
Z490GTA EVO