Deco Pixel Strip Drive3.0 Manual page 5

Pixel Strip Drive30 QRG
Mounting
The pixel-Strip Drive has four (4) mounting points (one on each corner) with 10mm holes to which you
can install screws and mount this product directly to almost any flat surface, truss, or other load bearing
structure in any orientation. The product may also be installed with clamps for hanging on truss. You must
supply your own clamps and make sure the clamps are capable of supporting the weight of this product.
Mounting Guidelines
We recommends using the following guidelines when mounting this product:
· Make sure to mount this product away from any flammable material as indicated in the Safety Notes
section.
· Never mount in places where rain, high humidity, extreme temperature changes, or restricted ventilation
may affect the product.
· Before deciding on a location, always make sure there is easy access to the product for maintenance
and programming.
· Make sure that the structure or surface onto which you are mounting the product can support the
product's weight (see the Technical Specifications).
· When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, such as an elevated platform or a truss.
· When rigging the product onto a truss, you should use a mounting clamp of appropriate weight capacity.
· When mounting the product on the floor, make sure that the product and cables are away from people
and vehicles.
Mounting Instructions
Mounting hardware is not included with the product
Using Mounting Clamps:
1. Attach the clamp to the mounting bracket.
2. Attach a safety cable to the product's safety loop.
3. Attach the clamp to the desired structure or surface.
4. Attach a safety cable through the mounting points
Using Mounting Points:
Pixel Strip Drive QRG
.
5
EN
EN