Buzzard Models AERONKISH Assembly Instructions

Download this manual

Please read and understand all steps to these instructions before beginning assembly. This plane is not a toy and

is very dangerous to operate. Children should not operate this aircraft without adult supervision.

Before you start, it may be a good idea to gather the required items to complete this plane. You will need some

glue, elmers school glue and some 5 minute epoxy will work. You will also need a micro receiver minimum 3

channels, a 2s 7.4 volt 300mah 20c lipo battey, a battery charger, and a 3 channel transmitter.

Fuselage parts

Repeat on other side.

Locate landing gear leg and press into

slot.

AERONKISH

Made in the USA by

Buzzard Models LLC

Locate fuselage sides, cabin top and two

5-1/8" bamboo rods

Glue front and rear fuselage bottom. Find

F1, F2, and F3. glue into place. Make

sure slot in F1 faces forward.

With one fus. Side temporarily in place,

glue gear plate on with foam safe CA ,

epoxy, or white glue.

With cabin top temporarily in place, glue

bamboo rod to fuselage side alining

bottom with bottom of doubler.

Locate cabin floor and cabin top, glue

into place.

Using white school glue, glue both

fuselage sides, front fuselage top and

firewall into place. Start at front.

Page 1 AERONKISH Made in the USA by Buzzard Models LLC Please read and understand all steps to these instructions before beginning assembly. This plane is not a toy and is very dangerous to operate. Children should not operate this aircraft without adult supervision.
Page 2 Use white glue and start from the front Using a low tack masking tape and some Find the two nose block pieces and fit and work backwards. Tape or clamp both clamps works well. Watch that you are into place, mark and shape with sides simultaneously working your way keeping fuselage straight.
Page 3 Slowly roll the leading edge back a few Apply glue liberally to wing roots. Tape roots together at leading and trailing times, progressivly until you get a shape edge, should form a 4.75” dihedral. that matches top of fuselage. Now is a good time to paint your parts. Mount motor mount to firewall with Assemble motor to speed control and Be carfull not to paint areas where you...
Page 4 2.5” behind the leading edge of the wing. It is vital that the center of gravity is checked before any flying is attempted. When flying the aeronkish, be aware that you can overload the wings. Sustained vertical dives can cause wing flutter, and high G maneuvers at high speed can break the wings.