Symmetricom ATS-6501 Tflex User Manual page 39

Command
delete_logs (ftp|rt) Deletes specified user ftp|rt logging configuration files.
diag Adjust diagnostic logging levels.
diag_port Switch to the diagnostic port (1800).
fix_position Sets a static location based on current GPS determined position location or
it allows the operator to enter the latitude, longitude, and altitude.
[current] or [<latitude> <longitude> <altitude>]. Default = Current.
frontpanel_button Enables(1) or disables (0) the front panel button from resetting the units IP
address if held in for ~10Seconds.
help, h or ? Display help for a command or list all commands. Proper format is to
<command> proceed the command with help, h, or ? help <command>
irig Allows the operator to set the IRIG codes on the 4394A (DC IRIG) and
4387A (AM IRIG) Cards.
latitude Sets latitude, Default [N], option [S] or [-].
list List available user configuration files available on disk. If there are no
files listed the ATS-6501 is using the factory default settings.
list_logs (ftp|rt). Lists the user gps logging settings for the ftp or real-time (rt) configuration
files. If there are no files listed the ATS-6501 is using the factory default
settings.
load Restore system configuration settings from a file on the disk
load_logs (ftp|rt). Restore the ftp or rt user logging configuration settings from file(s) on the
disk
log (ftp|rt) [type]. Add a GPS log. User must specify if the log is for ftp or real time (rt)
logs, and the log type desired from the Novatel receiver.
log_compression Enable or disable GZIP compression for the ftp log files. 0=Off 1=On
log_enable (ftp|rt) Enable or disable GPS logging, Specify ftp or real time (rt) then off|on.
0=Off, 1=On
log_filename Set name pattern of log files log_filename <user|timestamp>
Timestamp – files are named based on the date/time they were created
with an optional suffix. User – Users supplies file prefix name, Unique
ID, and suffix for the filename.
log_interval Sets the GPS logging interval for ftp files, in minutes log_interval
<interval in minutes> [1-1400]
log_number Sets the maximum number of GPS ftp log files. log_files <number>
longitude Set longitude. longitude <degrees> [E](default) or [W]
mask_angle Set mask angle. mask_angle <degrees>
nasa36 Allows the operator to enable the Nasa36 time code on the selected 4387A
(AM IRIG) card port.
network Show network interface configuration
network_config Set up network settings. [--mode DHCP|static] [--ip <ip>] [--mask
<netmask>] [--broadcast <broadcast>] [--gateway <gateway>]
position_mode Set GPS position mode. position_mode [auto|manual|dynamic]
position_period Set GPS auto-positioning period. position_period <period>
[h]ours(default) or [m]inutes.
pps Allows the operator to set the PPS parameters on the 4394A Card.
prompt Allows the operator to change the command prompt for the current session
or make the changes part of the system default settings.
Description
33
DOC06501_Revision F
ATS-6501 Users Guide