4 Label
TOOLS
•
Hot air flow solder station
•
Blunt pair of tweezers
•
Zebra printer and computer
INSTRUCTION
This instruction should be used when exchanging an old
label or assembling a new one.
Note the position of the label before removal!
One label only is allowed on the frame!
•
Read the old label and/or write the information into
the "Labelmake" program.
•
Heat up the label with a hot air flow solder station,
if needed.
•
Carefully remove the label and make sure that all
residues are gone.
If necessary, clean the surface with isopropyl
alcohol. Do not scratch the frame.
•
Check that the right label format is loaded in the
Zebra printer.
•
Write a new label by using the program
"Labelmake".
Check that the printing is ok.
•
Take the new label and place it onto the frame as
in the picture.
Make sure the label is placed in its proper position.
3/00021-1/FEA 209 544/107A
Company Internal
Sony Ericsson Mobile Communications AB
J210 Working Instructions - mechanical
28(29)