Page 3
Full – Green LED - Lights up once the connected battery is fully charged. Charge – Orange LED - Lights up during the charging process. Power – Green LED - Lights up whilst the charger is connected to the 230V / 50Hz mains socket. Mounting hook __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Thank you for purchasing TAGLab C4 Battery Charger. • The TAGLab C4 is suitable for charging open and a variety of closed, maintenance-free lead-acid batteries • as found in bike, cars, boats, and other vehicles, e.g.
NiCd or Lithium-Ion batteries with this charger. Never charge a frozen battery. If the liquid contained in the battery (acid) is frozen, the battery must be • defrosted. Then the battery can be charged. __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Page 8
Exterior force, damage to the device and / or damage to parts of the device caused by mechanical impact or • overload. Any type of modification to the device. • Use of the device for purposes that are not described in this instruction manual. • __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
This will void the Warranty. • Product Description TAGLab C4 is designed for charging wide range of lead acid batteries used for passenger cars, motorcycles • and certain other vehicles – e. g. WET batteries (with liquid electro-lyte), GEL batteries (with electrolyte in gel form) or AGM (absorbent glass mat) batteries.
If the battery is recognised to be defective or connected with the poles reversed, the “Error” LED (9) will light • up. In this case, disconnect the charger and check the battery and the correct connection (also see “Troubleshooting”). __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
230V / 50Hz mains power socket, the charger will supply power to car appliances (e.g. radio, stereo) automatically. "Charge" LED will light up during the power supply. • Alternator Testing (Available in selected models only) Connect the positive (+) and negative (-) clamps to the battery correctly, • __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
“Error” LED (9) lit. Charging Phases The charger uses a 9-stage charging process designed to optimally charge and maintain batteries. (The • below illustration show the charging phases when charging a 12V deeply discharged battery) __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Page 13
Stage 9: Restoring The charger monitors a fully charged battery automatically. If the battery voltage falls below 12.8V, the • charger will restart from stage 4 to stage 7. __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Disconnect the charger and check the connections. Battery voltage selected not correct (6/12 V) Disconnect the charger and wait for the LED indicator lamps to go out. Then reconnect the charger and adjust to the correct battery voltage. __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Page 15
Battery capacity too high for the charger used. Use a suitable charger. Battery voltage Battery not charged for long enough. Make sure that the battery was too low. charged for a sufficient amount of time. __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
The warranty applies only to material defects or manufacturing errors and not to wearing parts or damage to • fragile components, e. g. switches, cables. The warranty is rendered invalid by incorrect, inexpert handling, the application of force and tampering with • the device. **** **** ================================================================================== __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...
Page 17
Kencraft India Pvt Ltd, Andheri East, Mumbai 400069, INDIA. www.taglab.in __________________________________________________________________________________________________________________ TAGLab Battery Charger | C4...