Description And Operation Of Panel Parts; Resume Function - Toshiba AW-7480EM Owner's Manual

DESCRIPTION AND OPERATION OF PANEL PARTS

CHILD PROOF MODE DISPLAY
•
Check this to see if the CHILD
PROOF mode is ON (lit) or
warning (flashing).
"PRESET" button
•
You can set/reset the CHILD
PROOF mode.
•
You can set the time until
washing finished.
"SUPER SPIN DRY" button
DETERGENT GUIDE
•
The amount of supply using the measure spoon accompanying
the compact detergent is displayed.
One spoonful of detergent denotes about 55L of water consumption
Depending on the kind of detergents, amount of water consumption
by one spoonful changes. Adjust the detergent volume according to
the particular detergent in use.

RESUME FUNCTION

4
6348100701 (02-06)
PROCESS DISPLAY
•
Operating process is indicated by
flashing. Remaining process is
indicated by lightening.
"COURSE" button
•
You can select the program
suitable for the laundry.
"SELECT" button
•
Select either the WASH,
RINSE, or SPIN cycle as you
desire.
If a power failure occurs during operation, the washer memorizes the remaining
process. After the electricity recovers, you can resume it.
1 Turn the POWER on.
The progress and course indicators of the remaining process will be flashing,
and the buzzer sounds for 5 seconds.
2 Press the
2 1
NOTE • For "PRESET MODE" , if the power failure occurs before the machine starts
operating, the machine will cancel the preset time. Therefore, you have to
reset the time.
• Press the
4
•
Press this pad when you want to start.
•
Press this pad when you want to hold.
•
Press this button to power off/on.
•
Power is automatically turned off about 15
seconds after the end of operation, or about
10 minutes later if the operation is not on.
Auto-Set Mode
•
The water level is set linearly by adjusting to
the washing volume. If the water level is
assigned at the point with no particular
indication, then the nearest level lights up.
•
In this auto-set mode, the set water level
illuminates when water supply finishes.
•
By pressing the "START/HOLD" button while
water is in the wash basket, the highest
water level lights up.
Button Setting
•
By pressing the
water level can be obtained.
•
Illumination shifts to the direction where the
higher water level is indicated as the result of
pushing the
•
While using the "tub cleaning" program, the
water level will be automatically at High and
the
(POWER FAILURE RECOVERY)
button.
button to clear the remaining process.
22/10/08, 11:13
"START/HOLD" button
"POWER" button
WATER LEVEL
button, a desired
button.
button cannot be used.