Installation - Toshiba AW-7480EM Owner's Manual

Install your washing machine in a level, stable place.
•
It is dangerous to place the washing machine in an
unstable location, since it may move during vibration.
•
It will increase the sound produced by the machine when it
vibrates during use.
When you move washing machine, hold the handles on
the sides.
There are moving parts, electrical parts and steel plates
which may cause electrical shock or injury.
•
Never touch on the cabinet bottom by hands.
Never lift at the cabinet bottom by hands.
When the machine is covered.
Do not use the cover made of chloric vinyl. Sometimes it
damages resinous parts and painted surface. When you use
the cover made of chloric vinyl, put the cloth between the
machine and the cover.
Put the bottom cover into the bottom of the washing machine, and fix the bottom cover with screws.
1 Lay down the washing machine
on a flat object such as a corrugated board
so that the front side is down.
F R ONT
F R ONT
B OT TOM C OV E R (LE F T )
B OT TOM C OV E R (R IG HT ) S UP P OR T P LAT E
Adjust the legs so that the body of your washing machine is level. (The two legs are adjustable.)
After loosening the adjusting
1
nut, adjust the leg to the proper
height by turning it. Then
tighten the adjusting nut se-
curely once again.
Leg nut
Loosen
Tighten
Leg
Lower
Raise
6348100701 (11-15)

INSTALLATION

Choosing an installation location
Installing the bottom cover
2 Align the bottom cover with
the taps of the hooks of the
bottom cover left & right. (4 taps)
Installation
When the leg height is difficult to
2
adjust because of floor slope or
unevenness, place a board of
sufficient thickness to prevent
breakage under the affected legs
to allow adjustment to a level po-
sition.
11
Avoid place where the machine is exposed to direct sun-
light.
•
Plastic parts may become deformed or discolored.
Avoid places where the machine may become frozen
during cold weather.
Allow a space of at least 5 cm from the sides and rear of
the machine to the nearest vertical object.
•
When placed too near to walls or other objects, the
vibration of the machine during operation may cause them
to shake.
3 Fasten the screws on 6 positions.
A weight attached to a string may be used
3
to check to ensure that your washing
machine is level. The distance is less than
1 cm between A and B
22/10/08, 11:19
Allow 5 cm
String
Check the distance
11