Toshiba W-727 Owner's Manual page 38

®
DSS Satellite Receiver Set-up (continued)
Buttons to control a remote-
controllable DSS
Once you complete the set-up for a remote
controllable DSS ®
satellite receiver can be controlled by the
following buttons on the remote control of the
VCR.
• POWER (CABLE BOX)
To turn the DSS
• CH (CABLE BOX)
To select satellite channels in the upper or
lower direction. (not applicable to some brands
of DSS ® satellite receiver.)
• Number buttons (0 – 9)
To select desired channels to record.
38
OFF: if your DSS
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
receiver.
Go to step 8.
7
Select "BRAND TYPE" using STOP , and enter a brand code
of your DSS
to the table on the next page.
Example: For a TOSHIBA DSS
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG . twice to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
receiver will not be able to change channels in the timer recording. In this
case, set "CONTROL" to "OFF" in step 6.
• The VCR Plus+ C
• The DSS ®
control.
® satellite receiver
satellite receiver, your DSS
®
satellite receiver on or off.
®
satellite receiver is
®
satellite
®
satellite receiver using number buttons . Refer
3 system recording is not available on satellite channels.
®
satellite receiver control is not compatible with the cable box
Table of DSS
codes
®
Brand name of your
DSS ® satellite receiver
TOSHIBA
RCA
SONY
PANASONIC
®
®
satellite receiver, identified by
VCR display
® satellite receiver brand
Brand code
99
98
97
96
®
®
satetllite