Dss Satellite Receive Set-Up - Toshiba W-727 Owner's Manual

RECORDING
®
DSS Satellite Receiver Set-up
The VCR can directly control channel selecting of the connected DSS
DSS ® Satellite Receiver Control
This VCR needs to be connected to a DSS
satellite receiver equipped with an infrared
wireless remote control. You can select
satellite channels from the DSS
receiver by operating this VCR.
DSS ® is registered trademark of DIRECTV,
Inc., a unit of GM Hughes Electronics.
It is also possible to automatically change
the satellite channels according to your
program setting in the timer program
recording.
Placing the DSS
Receiver
®
Put the DSS satellite receiver on the top of
the VCR as shown below. Do not block the
sensor window.
®
DSS satellite receiver
Sensor window
The infrared signals come out of the sensor
window and received by the DSS
receiver. The VCR sends out infrared
signals to your DSS
during timer program recording.
Notes
• If the channels cannot be controlled properly
because the infrared signal fails to reach the DSS
satellite receiver, change the position of the
receiver on the VCR so that it can receive the
signal.
®
• Keep the DSS satellite receiver turned on even
while the VCR is in the timer program recording.
36
® satellite
® Satellite
® satellite
® satellite receiver even
®
Connection Type
®
Type A
Satellite
antenna
DSS ® satellite receiver
Type B
Satellite
antenna
DSS
LINE OUT
®
satellite receiver.
RF IN
RF OUT
3CH
4CH
RF IN
RF OUT
Incoming cable
®
satellite receiver
3CH
4CH
LINE IN 1