Basic Connections - Toshiba W525 Owner's Manual

BASIC CONNECTIONS

If you are using an antenna system, follow the instructions. If you are a cable (CATV) subscriber, skip ahead to
page 12 for the proper connections.
ANTENNA TO VCR CONNECTION
The VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and connect
it to the VCR. Then connect the VCR to the TV. Below are 3 common methods of connecting an antenna system to a
VCR. Find the type of antenna system you are using and follow the connection diagram.
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
1
Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire
2
Separate VHF and UHF Antennas
3
VHF
NOTE:
If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm
inputs and one 75 ohm output.
NOTES: • A clear picture will not be obtained by the VCR unless the antenna signal is good. Connect the antenna to the
VCR properly.
• For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an
outdoor type antenna is required.
• If you are not sure about the connection, please refer to qualified service personnel.
10
75 ohm Coaxial Cable
Matching Transformer
300 ohm Twin Lead (Flat) Wire
UHF
300 ohm Twin Lead (Flat) Wire
75 ohm Coaxial Cable
300 ohm Input
75 ohm output
(not supplied)
Combiner
75/300 ohm Inputs
75 ohm output
(not supplied)
VCR
IN
OUT
VCR
IN
OUT
VCR
IN
OUT