Replacing Starter Pawl - Yamabiko ECHO SRM-420ES Service Manual

SRM-420ES, SRM-420TES
T410S, B410S
T410TS, B410TS

2-5 Replacing starter pawl

d1
B
STARTER SYSTEM
A
B
C
D
F
d1
1. Remove starter assembly from unit.
2. Loosen bolt (A) and remove washer (B), pawl (C),
and torsion spring (D). Replace damaged or worn
parts.
NOTE: When it is hard to loosen bolt, install piston
stopper X644-000020 (E) in spark plug hole to stop
crankshaft rotation and remove bolt easily.
3. Install torsion spring (D), pawl (C), washer (B)
and bolt (A). To avoid pinching of torsion spring,
install these parts without setting the end of torsion
spring (d1) on starter pawl.
4. Using fi ne wire (F) or appropriate tool, place the
end of torsion spring (d1) on pawl (B), by hooking
and passing under pawl as shown. Remove fine
wire or tool.
5. Make sure pawl can move smoothly. If it does
not move smoothly, check parts for correct installa-
tion.
13 13
E