Introduction This product is an additional product designed to be used with the following Panasonic Video Intercom Systems. – VL-SWD275 (Main monitor station: VL-MWD275) – VL-SWD273 (Main monitor station: VL-MWD273) – VL-SWD272 (Main monitor station: VL-MWD272) – VL-SWD501BX (Main monitor station: VL-MWD501BX) (The corresponding models are subject to change without notice.)
Graphical symbols for use on equipment and their descriptions 1. Alternating current (A.C.) 2. Direct current (D.C.) 3. Protective earth 4. Protective bonding earth 5. Caution: risk caused by visible radiation 6. For indoor use only 7. Class P equipment (equipment in which protection against electric shock relies on Double Insulation or Reinforced Insulation) 8.
conductive material to overheat and cause burns. CAUTION R Only use the specified charger and AC adaptor to charge the batteries. Failure to follow these Preventing fire and electric shock instructions may cause the batteries to swell or R Do not use the product in areas that are explode.
Needs charging Charging the sub monitor R See page 6 for a guide on operating times for the Only connect the charger with the supplied Panasonic sub monitor. AC adaptor (→ page 2). Note: R When the sub monitor is off the charger or the AC...
the batteries in order to maintain battery Main monitor: performance and prevent the batteries from Press M discharging. – Recharge the batteries before using the sub monitor again. Cleaning Wipe the product with a soft, dry cloth. Wall mounting For excessive dirt, wipe the product with a cloth slightly dampened with fresh water.
Page 7
Charger Power source AC adaptor (PNLV226) 5.5 V DC, 0.5 A Power Standby: 0.6 W consumption (when the sub monitor with full- charged batteries is placed on the charger) During charging: 1.6 W Dimensions Approx. 43×81×76 (mm) (height × (excluding protruding sections) width ×...