Cisco 3600 Series Configuration Note page 19

Figure 21 Cisco 3640 DC-Input Power Supply Connections
Ground
Terminal block
Turn ON the power switch. The power LED on the front panel of the router should go
Step 3
ON.)
Verify that the OK LED on the right side of the front panel goes ON after a few seconds'
Step 4
delay when booting. If you have problems, see the next section, "Troubleshooting," and
the section "Obtaining Service and Support" later in this document.
Secure all power cabling when installing this unit to avoid disturbing field-wiring
Warning
connections. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied the router.)
This equipment is intended to be grounded. Ensure that the host is connected to earth
Warning
ground during normal use. (To see translated versions of this warning, refer to the Regulatory
Compliance and Safety Information document that accompanied the router.)
Negative
Terminal block
Cisco 3600 Series Power Supply Configuration Note
Replacing Connections to the Router
Positive
On/off
19