Table of Contents
Advertisement
Faults
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash cycle.
Odours, stain formation in
the appliance.
Loud noises, vibrations
and appliance "move-
ment" during the spin
cycle.
The display panel indica-
tor lights do not work
while the appliance is run-
ning.
There is detergent resi-
due on the laundry.
Spin noise during the dry-
ing phase.
Fluff found on the laundry. Run the Cottons i 90°C — (cold) programme without laundry and detergent
Cause/Remedy
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above the max. mark.
Not a fault – the unbalanced load detection system has interrupted the
■
spin cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
Is Easy iron additional programme setting selected (depending on the
■
model)?
Is Night Wash additional programme setting or Night Wash programme
■
selected (depending on the model)?
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system is activated – a rinse cycle has
■
been switched on.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Run the Cottons i 90°C programme without laundry.
Add washing powder or a detergent containing bleach.
Note:
To prevent foaming, only use half the amount of detergent recommend-
ed by the detergent manufacturer. Do not use detergents designed for woollens
or delicates.
Is the appliance aligned? ~ "Alignment" on page 19
■
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport locks been removed? ~ "Removing the transport
■
locks" on page 14
Has there been a power failure?
■
Have the fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select Rinse à or brush the laundry after washing.
■
This is an innovative process known as thermal spinning used to reduce energy
consumption during the drying phase.
to remove fluff which have accumulated inside the drum during the previous
drying cycle.
Faults and what to do about them
en
47
Hide quick links:
Advertisement
Table of Contents
