Advertisement
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
READ AND FOLLOW ALL SAFETY
WARNING: RISK OF ELECTRIC SHOCK – NEVER CONN
EQUIPMENT IS ENERGIZED.
Warning: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH,
SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these
warnings and instructions carefully before installing or maintaining this equipment. These instructions
do not attempt to cover all installation and maintenance situations
Warning: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe
lamp manufacturer's warnings, recommendations and restrictions on lamp operation and maintenance.
Make sure lamps are correctly installed.
•
All service shall be performed by qualified service personnel. This product must be installed and
maintained in accordance with the applicable installation codes by a person familiar with the construction
Operation of the product and the hazards involved.
•
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect A.C. power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
May be used outdoors under cover (20°C - 50°C)
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Equipment should be mounted in locations at heights where it will not readily be subjected to tampering by
unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause and unsafe condition.
•
Do not use this equipment for other than intended use.
•
The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any
other voltage.
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
always be followed including the following.
INSTRUCTIONS
Battery Backup Exit and Unit Combo
NECT TO, DISCONNECT FROM, OR SERVICE WHILE
CLSC
Advertisement
Table of Contents
Related Manuals for HUBBELL LIGHTING DUAL LITE CLSC Series
Summary of Contents for HUBBELL LIGHTING DUAL LITE CLSC Series
- Page 1 CLSC Battery Backup Exit and Unit Combo IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following. READ AND FOLLOW ALL SAFETY INSTRUCTIONS WARNING: RISK OF ELECTRIC SHOCK – NEVER CONN NECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
- Page 2 INSTALLATION SURFACE MOUNT INSTALLATIONS 1. Remove retainer screw from right side of the sign. Remove side panel and mounting canopy, set aside. 2. Remove retainer screw from the front cover of the unit. Remove the front cover and set aside. 3.
- Page 3 OPERATION OPERATION: EXIT – LED lamps will stay on in AC mode and remain on in the Emergency mode. To perform test, press test switch. LAMP HEADS –To test the equipment, depress the TEST switch. The charge (LED) indicator will turn OFF and the emergency lights will illuminate.
- Page 4 All cartons contain recycled materials. Please recycle responsibly. Hubbell Lighting, Inc. Life Safety Products • dual-lite.com Copyright Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A. © DL_INST_SHT 10/16...
Need help?
Do you have a question about the DUAL LITE CLSC Series and is the answer not in the manual?
Questions and answers