Invacare MK5 NX Service Manual page 23

To change the programmed value for an option (i.e. Acceleration - FWD), press the
so the selection arrow points to Acceleration - FWD.
FORWARD SPEED
TURNING SPEED
➜ ACCELERATION - FWD
ACCELERATION - REV
Press the SELECT key. The display screen changes to the adjustment screen. The top line
shows the function. The second line shows the value. At the bottom is a bar graph which
shows the relative position of the current value to the total adjustment range. Pressing the
or key will adjust the value.
ACCELERATION - FWD
35%
[
Pressing the key causes the value to increase and the bar graph to move to the right.
Pressing the key causes the value to decrease and the bar graph to move to the left.
ACCELERATION - FWD
70%
[
To save this change, press the SAVE key.
When saving to the drive program is complete, the screen will change to display:
CHANGES SAVED TO
*RWD - 2 POLE
CONTINUE? PRESS MENU
QUIT? PRESS POWER
*NOTE: The driving program selected is either RWD-2 Pole, RWD - 4 Pole, or CWD 2 - Pole.
Refer to the flow chart in NX, NX-50, NX-75, NX w/ACC, and NX-B Controller on page 24 or
NX-LP Controller on page 26.
Pressing the MENU key allows the adjustment sequence to be repeated for other driving
programs.
Part No 1110532
SECTION 5—PERFORMANCE ADJUSTMENTS
]
]
23
key
MK ™NX™Electronics
5