Function Display; Mode Check Display - Panasonic AK-HVF100G Operating Instructions Manual

On-screen display

Function display

F1 : MONO
F2 : WFM
F3 : FOCUS-IN-RED
F4 : MARKER
1
Press the <F1>/<F2>/<F3>/<F4> button.
Function assigned to each button and the condition of that function is displayed.
f This display disappears after two seconds of inaction.
f Display condition can be changed with [MAIN MENU] → [FUNCTION] → [FUNCTION DISPLAY].
f The function assigned to each button will memorize the condition before turning off the power even if the power of the unit is turned off. However,
[FOCUS-IN-RED] and [CAM MENU] will return to disabled.

Mode check display

Current setting condition can be displayed.
Perform while the menu is not displayed.
1
Press the <SELECT> dial button.
The setting condition is displayed.
Display disappears when there is approximately two minutes of inaction.
f [BRIGHTNESS]: The value adjusted with the <BRIGHT> knob.
f [CONTRAST]: The value adjusted with the <CONTRAST> knob.
f [PEAKING]: The value adjusted with the <PEAKING> knob.
f [BACK LIGHT]: The value set with [MAIN MENU] → [VIDEO CONFIG] → [BACK LIGHT].
f [INPUT SELECT]: Input selected with the <INPUT> switch.
f [INPUT FORMAT]: Format of the video signal currently input.
f [FUNCTION1]: Function assigned to the <F1> button.
f [FUNCTION2]: Function assigned to the <F2> button.
f [FUNCTION3]: Function assigned to the <F3> button.
f [FUNCTION4]: Function assigned to the <F4> button.
f [ASSIGN]: Function assigned to the <SELECT> dial button.
f [TALLY ASSIGN]: The illumination condition set with [MAIN MENU] → [SYSTEM CONFIG] → [TALLY ASSIGN].
26
<F1>/<F2>/<F3>/<F4> buttons
MONO ON
[ MODE CHECK ]
BRIGHTNESS
CONTRAST
PEAKING
BACKLIGHT
INPUT SELECT
INPUT FORMAT
FUNCTION1
FUNCTION2
FUNCTION3 FOCUS-IN-RED
FUNCTION4
ASSIGN
TALLY ASSIGN
<SELECT> dial button
30
50
15
100
CAM
1080i 59.94
MONO
WFM
MARKER
UNDEF
OFF