Mitsubishi Electric MP-G10-AH Technical Manual page 12

5.2 Return to home position
(1) Turn the sewing machine power switch ON.
(2) Conf irm that the work holder lowers when the f oot switch (2-pedal) [ Black]
side is turned ON, and rises when the switch is turned ON ag ain.
(3) Conf irm that the label holder lowers when the expanded f oot switch
(1-pedal) is turned ON, and rises when the switch is turned ON again. The
label holder will not move even if the foot switch is depressed unless the
work holder is lower ed.
(If proper operation is not possible, ref er to the Setup Pr ocedur es and
check the settings and connections.)
(3) Lower the work holder and label holder, and press
panel. Retur n to hom e position will start.
6. Preparing to stitch labels
6.1 Stitching conditions
(1) Stitching size
Label holder（mm）
A
Max Min.
100
(2) Stitching material thickness: 4mm or less
(3) Super imposed stitching length (Fig. 1 T dimension) ... 12mm or less
(4) Restrict ions
Input the stitching data in a clockwise direction ( dir ection of bold arr ow in Fig.
1). The ent ire per ipher y cannot be stitched when the data is input in the
reverse direct ion (counterclock wise direction).
The presser f oot (cylindr ical presser) and wiper mechanism cannot be used.
Remove these parts.
6.2 Preparing the label holder plate
Prepare the label holder plate with the following procedures to match the size
of the label to be sewn on.
(1) Remove the Fig. No. 140 round screw, and remove the Fig. No. 139 label
plate mounting block and Fig. No. 142 label holder plate.
B
Max Min.
35 80 28
Start of stitching
(Look ing from front of sewing machine)
- 10 -
on the operation
End of stitching
Fig. 1