Haier HTF-540DGG7 User Manual page 22

EN
1. Press contorl panel button „C" to turn on the ice maker function.
2. Discard the first full bin of ice made. Clean the ice box with water and install it back.
Your ice maker is now ready for use.
3. Repeat step 2 to remove dust in the ice tray collected during manufacture and trans-
port.
4. Empty the water, dry the bin und return it correctly.
5. Once your ice maker is turned on the first bin of ice may be discoloured. This is not
harmful and normal during the flushing process. Discard the first full bin of ice made .
Your ice maker is now ready for use.
Carry out the above steps after a holiday/vacation or extended periods of not using ice.
Notice
The performance of your water filter will increase with use, reaching optimum perfor-
mance after two to three full bins of ice.
Turn ice maker off if:
• There is no water supply for serveral hours.
• Your are removing the ice storage bin for a period of time.
• You are going on holiday/vacation.
Information about the ice maker
• Your automatic ice maker will produce approximately eight cubes of ice every 2 hours,
depending on the freezer compartment temperature and the number of door openings
• The ice cube tray will fill with water.
• When cubes are frozen, they will be ejected from the ice tray into the ice storage bin.
• Ice making will continue until the storage bin is full.
• Ice making will resume once you start to use the stored ice.
• Your Ice and Water product comes with a smaller ice bin inside the larger freezer bin.
• Attached to the ice storage bin is the scoop for the ice. This scoop provides hygienic access to the ice.
• If a large amount of ice is required, remove an ice storage bin and allow ice to fall into the
larger bin.
• If ice is not used often, old cubes will become cloudy, taste stale, will shrink and may stick
together. Empty the ice storage bin periodically and wash in lukewarm water. Dry thoroughly
and place back into the correct position.
WARNING!
▶ Avoid contact with the moving parts of the ice maker ejector mechanism, and do not place
your fingers on the automatic ice making mechanism while the refrigerator is in operation.
▶ Do not use ice cubes that may have become discoloured, usually with a green-blue
colour. I f such discolouration is noted, discard the ice cubes and contact your Haier
trained and supported service technician.
▶ Ensure the ice maker is connected to the filter and to a drinkable water supply only.
▶ Installation of the water connection to the ice maker must be completed by a Haier
trained and supported service technician or a qualified plumber.
Use
.
19