Table of Contents
Advertisement
FILTER
•
Never use the dishwasher without filters! The performance may be affected and dishes
and utensils could become damaged.
•
Make sure the filter is properly assembled.
•
The entire filter assembly should be cleaned once a week. Remove food remnants and
clean the filters under running water.
•
The filter efficiently removes food particles from the wash water, allowing it to be
recycled during the cycle. For best performance and results, the filter assembly must
be cleaned regularly. For this reason, it is a good idea tore move the larger food
particles trapping in the filter after each wash cycle by rinsing the filter and cup under
running water.
STEP 1: Rotate the filter assembly
counter-clockwise, then lift up.
STEP 2: Lift the fine filter up from
the main filter
15
FDW05ASBWHA_Manual_vF.indd 15-16
B. FINE FILTER
This filter holds soil and food residues in
the sump area and prevents it from being
deposited on the dishes during wash cycle.
A. MAIN FILTER
Food and soil particles trapped in this filter are
pulverized by a special jet on the lower spray
CARING FOR THE DISHWASHER
•
The control panel and exterior be cleaned by using a lightly dampened cloth. After
cleaning, make sure to dry it thoroughly. .Never use sharp objects, scouring pads
or harsh cleaners on any part of the dishwasher. To remove spots or stains from the
surface of the interior, use a cloth dampened with water an a little vinegar,
•
To clean the edge around the door, you should use only a soft warm, damp cloth. Avoid
penetration of water into the door lock and electrical components.
•
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components. Abrasive agents or some paper towel should not be used
because of the risk of scratching or leaving spots on the stainless steel surface. Protect
against freezing
•
Take the following frost protection measures for he dishwasher operation in winter.
•
After each wash cycle perform the following:
1. Cut the power to the unit
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve (Use a pan to catch the water).
4 Remove the filter at the bottom and use a soft cloth to soak up any residual water.
5. If your dishwasher cannot work because of the ice, please contact authorised
service person.
CLEANING THE SPRAY ARMS
•
The spray arms can be easily removed for periodic cleaning of the nozzles to prevent
possible clogging. Wash them under running water and carefully replace them in their
seats, checking that their rotary movement is in no way impeded.
•
Grasp the middle of the spray arm, pull it upwards to remove it. Wash the arms under a
jet of running water and replace it carefully to its seat. After reassembly, check that the
spray arms rotate freely. Otherwise, check that they have been installed correctly.
16
5/20/19 3:08 PM
Hide quick links:
Advertisement
Table of Contents
