Troubleshooting - Farberware FDW05ASBWHA Use And Care Manual

TROUBLESHOOTING

Problem Possible Causes
Dishwasher doesn't start Fuse blown, or the
circuit breaker tripped
Power supply is not on
Error code:E1 Water
pressure is low
Door of dishwasher is
not closed properly
Water not pumped Twisted or trapped
form dishwasher drain hose
Filter clogged.
Kitchen sink clogged.
Suds in the tub Wrong detergent.
19
FDW05ASBWHA_Manual_vF.indd 19-20
What To Do
Replace fuze or reset
circuit breaker
Make sure the dishwasher
is turned on and the
door is closed securely.
Make sure the
power cord is
properly plugged into
the wall socket.
Check that the
water supply is
connected properly and
the water is turned on.
Make sure to
close the door
properly and latch it.
Check the drain hose.
Check the filter.
Check the kitchen
sink to make sure it
is draining. If not you
may need a plumber.
Use only the dedicated
dishwasher detergent.
If suds exist, Open the
door for 20-30min. to
allow the foam to
evaporate. If foam
persists, add 1/3 gallon of
water, close the door and
run a force drain. Repeat
until foam is cleared.
Problem Possible Causes
White film on Hard water minerals.
inside surface
There are rust The affected items are
stains on cutlery not corrosion resistant.
Knocking noise in A spray arm is knocking
dishwasher against an item in a basket
Rattling noise in Dishes are not positioned
the dishwasher properly in the dishwasher.
The dishes are not clean The dishes were not
loaded correctly
You did not select
the correct cycle
Not enough detergent
Items are blocking
the spray arms
The filter is not clean
Cloudiness on glassware Combination of soft water
and not enough detergent
White spots on dishes Hard water
Black or grey marks Aluminium utensils
on dishes have rubbed dishes
What To Do
To clean the interior,
use a damp sponge with
dishwasher detergent
and wear rubber
gloves. Never use
any other cleaner
than dishwasher
detergent otherwise,
it may cause
foaming or suds.
Avoid washing items that
are not corrosion resistant
in the dishwasher
Interrupt the cycle
and rearrange the
items which are
obstructing the spray arm.
Interrupt the cycle and
rearrange the items
which are not in the
proper position.
See notes in "Loading
& unloading section.
Select a more
powerful cycle.
Check the cycle chart
to assure you are using
the correct detergent
and correct amount
of detergent.
Rearrange the items
so that the spray arms
can move freely.
Clean the filter.
Try using the glassware
cycle and using the
correct detergent.
Try adding more detergent.
Check that dishes
are loaded properly
and not rubbing
against each other.
20
5/20/19 3:08 PM