Advertisement
GardenShed
Step 7:
Fit the panels together (continued)
Step 7: Fit the panels together (continued)
Repeat the same step for the other assembled roof panel. Drill holes for roof brace using 3mm drill bit. Then fix the roof brace as
Repeat the same step for the other assembled roof panel. Drill holes for roof brace using 3mm drill bit. Then fix the roof brace as per diagram
per diagram below. Join the sheeting and the gable using part 54 (lip) and then fix the 4 corners using 16mm self-tapping screws.
below. Join the sheeting and the gable using part 54 (lip) and then fix the 4 corners using 16mm self tapping screws. Note: Do not fix central
Note: Do not fix central screws marked with a cross at this stage).
screws marked with a cross at this stage.
PARTS 26A AND
26B (CHANNELS)
ON THIS END
© Jack Sealey Limited
2.3 x 2.3 x 2.4m
96
PARTS 26E AND 26F
(CHANNELS) ON THIS END
54
Original Language Version
After attaching both roof panels to the walls, drill
AFTER ATTACHING BOTH ROOF
PANELST OW ALLS AS SHOWN ABOVE,
holes through the roof brace using a 3mm drill bit
After attaching both roof panels to
DRILLT HE HOLES THROUGHB Y3 MM
and fix the brace to the ridge beam and channel
the walls, Drill holes through the roof
DRILLB IT FORT HE ROOFB RACE AND
above the door, as per the diagram on the left.
brace using a 3mm drill bit and fix
FIX IT TO THER IDGE BEAMA ND FRONT
Repeat this step for the rear wall roof brace.
brace to the ridge beam and channel
WALL AS SHOWN. REPEAT THE SAME
above door as per the diagram on
STEP FORT HE ROOFS IDE.
the left. Repeat this step for the rear
THEN REPEATT HISP ROCEDUREF OR
wall roof brace.
THE REARW ALLR OOFB RACE
54
54
54
54
S17
94L
GSS2323/G | Issue:2(SP) 13/04/17
Advertisement
