Bell System Practices 200 Series Reference

BEtt SYSTEM PRACTICES
P lonl Se ries
sEciloN 502-30t-l0r
lssue l, Morch l97O
AT&ICo Slondord
2.Ol Basic
Sets:
I.
GENERAI.
l.0l This section provides identification, installation,
maintenance, and connection information for
t he 21 lJ R , 21 1 LR , 2 1 1 M R , 2 1 l N R , a nd 2 1 l P R h a n d
telephone sets. This information was formerly
f o un d in Se c t i o n s , 5 0 2 - 1 2 0 - 2 0 1 , 50 2 - 2 0 0 - 4 0 4 ,
502-200-406, 502-300-100, 502-300-300, 502-302-40jt,
and 502-303-404. Sections 502-302-403 and 502-302-404
are herebv canceled.
2. IDENTIFICATION
O rd e r in g G u i de
Hang-up Type Hand Telephone
jSet, Telephone, Hand, 211JR-3
jSet, Telephone, Hand, 211LR-3
1Set, Telephone, Hand, 211MR-3
1Set, Telephone, Hand, 211NR-3
3Set, Telephone, Hand, 211PR-3
Note:
These sets are available in bl:rck (-3)
only.
REFERENCE
2I I.TYPE HAND TETEPHONE
SETS
TABTE
COMBIN A TI ON OF
American Tclt'phone and Telegr:rph Conrpany, 1970
P r i nt ed i n U .S . A.
2.O2 Replaceable components are listed in Table A.
2.03 AssociatedApparatus:
1Set, Subscriber, 685A-Refer to Table B
jSet, Subscriber, 686A-Refer to Table B
2.04 These sets are primarily designed for wall
or desk mounting and can be used on 0O
and PBX lines, and with 1A1, 1AZ KTS and 3-type
speakerphone systems.
2.O5 Refer to Table B for class of service.
3. INSTATLATION
Foslening Slolion Sels
3.0I Telephone sets, subscriber sets, and associated
station apparatus should be fastened securely
to a substantial mounting surface. Refer to Table
C for recommended fasteners.
3.02 Where wire is not concealed at subscriber
set or wall set, a fastener should be placed
approxirnately 2 inches from the set.
A
APPARAIUS
HANO
IEt sET
CODE
REPTACEABTE COMPONENIS
HANDSET
HANDSEI
MIG
D I A 1 O R
APPARATUS
B]ANK
DIAI.
AAIG
H A N D S E T
C O R D
211JR-3
G3AR.3
G6-3
No. Card
Holder
H4CJ-3
211LR-3
6A-3
43A-3
211MR-3 6D-3
211NR-3
G8-3
No. C:rrd
Holder
211PR-3 6J-3
43A-3
Po g e I