Powering And Operation - Maxview VuQube II MXLO23W Owner's Manual

Powering and operation

The VuQube II is preset to Astra 2, this means your system is ready to search for your favourite UK
channels. (The Mainland European VuQube II is preset to Astra 1, this means European users can also
immediately search for their favourite channels.)
In most cases your pre-set satellite will be the one you wish to search for, in this case, please skip to the
Satellite Search Section now (page 8).
The VuQube II supports the following Satellites: Astra 1 - Astra 2 - Astra 3 - Hotbird.
Please see table below to understand how the lights correspond to these satellites.
If you would like to change the satellite which your VuQube II searches for please use the following process:
If your VuQube II is new skip this step and go straight to page 8
Make sure the LED is flashing green (ready to scan)
Green
Off
1. To enter the Configuration Mode - Press and hold (6 seconds) the
power insterer button until one of the options below appears.
2. Press and release as needed to choose satellite below
ASTRA 1
Blue Off
ASTRA 2
Green Off
ASTRA 3
Yellow
Off
HOTBIRD
Purple Off
3. Press and hold (3 seconds) until LED flashes chosen satellite colour - (Ready to to scan)
Chosen
Note. This will now remain the pre-set satellite on the power inserter until this process is
repeated. Go to page 8 to start scan. The LED will flash on and off unless you have enabled
the alarm function (see page 10) in which case the LED will flash the colour and white.
06
Green
Off
Pattern repeats
Off
Green
Yellow
Off
Purple Off
Chosen
Off
Green
Off
Pattern repeats
Off
Yellow
Purple Off
Chosen
Off
Pattern repeats
Purple
Off
Pattern repeats