Network Deployment - Toshiba IK-WB70A User Manual

Network deployment

Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet connection.
1. If you have external devices such as sensors and alarms, make connection from
general I/O terminal block.
2. Use the supplied RJ45 female/female coupler to connect the Network Camera
to a network port via an Ethernet cable. Use Category 5 Cross Cable when the
Network Camera is directly connected to a PC.
3. Connect the power cord socket from the Network Camera to the supplied AC
adapter.
There are three ways to setup the Network Camera over the Internet. The first way
is to setup the Network Camera behind a gateway. The second way is to utilize a
static IP. The third way is to use PPPoE.
Internet connection via a gateway
Before setting up the Network Camera over the Internet, make sure you have a
gateway and follow the steps below.
1. Connect your Network Camera behind a gateway, a network environment
example is illustrated as below. Regarding how to get your IP address, refer to
Software installation on page 18 for details.
Cable or DSL Modem
2
1
WAN (Wide Area Network)
Router IP address : from ISP
LAN (Local Area Network)
Router IP address : 192.168.0.1
1
Ethernet
switch/router
(not supplied)
3
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default gateway : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default gateway : 192.168.0.1
N.C.: No connection
N.C.
485B: RS485-
485B
485A: RS485+
485A
AC24V
AC24V: 24 VAC Power Input
AC24V
AC24V: 24 VAC Power Input
GND: Ground
GND
DI : Digital Input
DI
DO DO : Digital Output
+12V
+12V : 12 VDC Output
15