In Case Of Problems; Notes On Use And Installation; Specifications - Toshiba IK-6420A User Manual

10. NOTES ON USE AND INSTALLATION

• Do not aim the camera at the sun
Never aim the camera at the sun even with the camera power off.
• Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on
the screen. However, this is not a malfunction.
• Treat the camera with care
Do not drop the camera or subject it to intense vibration.
• Never touch internal parts
Do not touch the internal parts of the camera other than the parts specified.
• Do not splash water on the camera
Install the camera where the camera can be kept dry. If the camera gets wet, turn off the power
and contact your dealer.
• Keep the camera installation away from video noise
If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this
event, relocate cables or reinstall equipment.
• Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than the specified operating
range. Doing so could affect the internal parts or cause the image quality to deteriorate. Special
care is required to use the camera at high temperature and humidity.
• Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power and contact your dealer.
If you continue to use the camera when there is something wrong with it, the trouble may get
much worse and an unpredictable problem may occur.

11. IN CASE OF PROBLEMS

Condition
Are the camera and connected equipment turned on?
No image Is the iris of the lens adjusted properly?
Are cables connected correctly?
Is the monitor TV adjusted correctly?
Unnatural color
Is the lighting too dim?
Check Point
- 12 -

12. SPECIFICATIONS

24V AC ~ ±10% 60Hz / 12V DC
Power
Power consumption 3.5W with Al lens
Image sensor 1/3 inch CCD image sensor
Image pickup area 0.194 inch (4.92 mm) horizontal x 0.145 inch (3.69 mm) vertical
Effective picture element 510 horizontal x 492 vertical
Scanning system 2:1 interlace NTSC Standard TV system
Scanning frequency 15.75 KHz horizontal 60 Hz vertical
Synchronization Line-Lock, Internal manually switchable
Resolution 350 Horizontal TV lines
0.2 lux (F1.2, More than 10% of image output γ = 0.45)
Minimum illuminance of subject
S/N 50 dB or more (weight ON)
Video output VBS 1.0 V p-p / 75 ohms, composite
Output impedance 75 ohms unbalanced
White balance Automatic (2500 K to 10,000 K)
Iris control Video Out / Iris Driver Circuit Built in
Gain control Average AGC (26 dB)
Backlight compensation Manual ON/OFF switching, center zone light measuring system
Lens mount CS mount
Ambient temperature 14˚F to 122˚F (-10˚C to +50˚C)
Ambient humidity 20% to 80%
Weight 0.77 lbs (350 g)
External dimensions 2.48(W) x 1.97(H) x 4.57(D) inches (63(W) x 50(H) x 116(D) mm)
Automatic electronic shutter ON (1/60 s to 1/100000 s) /OFF (1/60 s)
IK-6210A
±10%
- 13 -