Beastx MICROBEAST PLUS Quick Start Manual page 5

Dear customer,
thank you for purchasing our product.
MICROBEAST PLUS is a high-end flybarless system for RC helicopters that has been developed in Germany
using latest technology and setting high standards. This system can be used with nearly any size and type
of RC helicopters and besides using it as flybarless stabilization system it offers additional features that can
make flying helis even easier and comfortable.
To program MICROBEAST PLUS we consciously decided against using a tiny display that might be hard
to read or using an external programming device such as a smart phone or PC software. The „EasySetup"
concept allows to setup the helicopter in a very short amount of time and without the need of additional
devices which you might have forgotten at home when on the flying field. You can setup your helicopter
anytime and anywhere and you're ready for take off within a few minutes.
This Quickstart Guide is a clearly arranged guide that will lead you step-by-step through the basic flight
setup. Please follow this guide carefully and make sure to read the attached safety notes. For a detailed
instruction manual and a lot more details, tipps, tricks and notes about the product please visit
WIKI.BEASTX.COM
StudioX allows to edit, save and load the device setup by using a PC. Additionally it can
be used to register your device and aquire optional features. Also it allows to perform
very special setups like such as a virtual swashplate rotation for multiblade rotorheads.
To connect your MICROBEAST PLUS to the computer the optional available USB2SYS
interface is required.
StudioX can be downloaded from:
STUDIOX.BEASTX.COM
This guide only is intended to be used with MICROBEAST PLUS firmware version 4.1.x!
You can see what firmware version your MICROBEAST PLUS is
running when it is powered on. First the device carries out a
brief LED test. Then for about 3 seconds the Status-LED lights
red while the Menu-LEDs A - G display the first digit of the
firmware version and the LEDs H - N the second digit of the
firmware version.
QUICKSTART GUIDE V4.1
Firmware version: 4.1.x
In the left row Menu-LED C stands for major
version „4". In right row Menu-LED H shows
minor version „1".