Anvil Foundry Assembly & Maintenance Manual page 2

Assembly
Lid Assembly
Place the knob washer on the top and
bottom of the lid in the center. Put the
screw through the bottom of the lid
into the knob. Do not over tighten.
Valve and Rotating Dip Tube Assembly
Assemble the valve handle to the valve with the valve nut and lock washer as shown below. Do not overtighten the nut.
Attach the valve through the hole in the Foundry™. Place all parts
in order as shown. When assembled correctly, the valve and dip
tube can be rotated to leave behind trub in the bottom of the
kettle. Tighten the valve firmly but not so tight that the valve
doesn't rotate by hand.
Use the rotating valve at the end of your boil to transfer clearer
wort.
Tip: Install the dip tube facing the same direction as the
closed valve handle so you know the position
Basket Support Ring Assembly
Place the basket support ring into the top of the Foundry™. The basket support ring will fit
firmly into the top. If the ring does not fit firmly, stretch out the ring until it fits snugly. This
will prevent the ring from popping out accidentally.
Warning: Be careful not to dislodge the support ring while lifting the basket.
Immersion Chiller
Place the immersion chiller into your boiling wort
5 to 10 minutes before the end of your boil to
sanitize. Place the drain hose down the drain.
Once you're ready to chill, send cold water
through the coil with the garden hose connection
until it reaches fermentation temperature.
Stir the wort with a sanitized spoon while cooling
to increase cooling speed.
Warning: Water coming out the drain hose will be hot.
Anvil Brewing Foundry™ - V4
©Anvil Brewing Equipment 2019 | www.anvilbrewing.com
Knob Washer
Screw
Lid
Barb O-ring
Barb
Barb
Nut
Drain
2
Knob
Foundry™ Kettle Wall
O-ring
O-ring (inside dip tube)
Teflon
Valve
Washer
Outside Foundry™
Outlet
Inlet
Valve Nut Dip Tube
Inside Foundry™
Cold Water
Supply