Table of Contents
Advertisement
Troubleshooting
1.
If the wort is flowing at the recommended flow rate but is flowing over the sides of the basket instead of through it, you
may have a stuck mash caused by compacting the grain. This is caused by recirculating too fast, too fine of a grain
crush, or a high percentage of wheat, oats or similar grains in the grain bill. If this occurs, turn off the pump, and stir the
entire mash. Add 1/4 to 1/2 pound of rice hulls if available and stir in well. Let the mash sit for 10 minutes before
re-starting circulation.
2.
If the Foundry™ does not turn on when powered up, see Power Source Overview for more information.
3.
If the unit is accidentally ran without water the dry run switch will cut the power to the heaters. An error code "E3" will
appear to reset:
1. Turn off the unit and disconnect from power.
2. Allow the unit to cool.
3. Flip over the Foundry™ and depress the pin to reset.
Anvil Brewing Foundry™ - V4
©Anvil Brewing Equipment 2019 | www.anvilbrewing.com
10
Hide quick links:
Advertisement
Table of Contents
