Troubleshooting - Brandt BFU584YNW Instruction Manual

Caution!
-Don't use sharp objects as they are
likely to scratch the surface.
-Don't use Thinner, Car
Clorox, ethereal oil, abrasive cleansers or
organic solvent such as Benzene for
cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
-Wipe the inside of the fridge freezer
with a weak solution
bicarbonate, and then rinse with warm
water using a wrung-out sponge or cloth.
-Wipe completely dry before replacing
the shelves and baskets. Thoroughly dry
all surfaces and removable
Although this appliance automatically
defrosts, a layer of frost may occur on
the refrigerator's interior walls if the
door is opened frequently or kept open
too long. If the frost is too thick, choose
a time when of food stocks are low and
proceed as follows:
-Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors open.
Ventilate the room
accelerate the thawing process.

Troubleshooting

If you experience a problem with your appliance or are concerned that the appliance is
not functioning correctly, you can carry out some easy checks before calling for service,
please see below. You can carry out some easy checks according to this section before
calling for service.
Warning! Don't try to repair the appliance yourself. If the problem persists after you
have made the checks mentioned below, contact a qualified electrician, authorized
service engineer or the shop where you purchased the product.
Caution! Don't use sharp objects to
remove frost from the refrigerator.
Only after the interior is completely dry
detergent,
should the appliance be switched back
on and plugged back into the mains
socket.
Door seal cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash the seal with
a mild detergent and
Rinse and dry it thoroughly after
cleaning.
of sodium
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light
parts.
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged,
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
thoroughly to
pressing the connector latch.
4. Replace LED light and snap
correctly in place.
18
warm water.
contact the customer
it