Installation - Brandt BFU584YNW Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 23
Some packing materials of this device are
also recyclable. Recycle them and play a
role in protecting the environment by
depositing them in the containers provided
for this purpose.
In accordance with the most recent
legislation on the protection and respect
for the environment, your appliance does
not contain HFC's, but a refrigerant called
R600a. The exact type of refrigerant used
in your appliance is also clearly indicated
on the rating plate located inside the
appliance, on the left wall down. R600a is
a non-polluting gas that does not harm the
ozone layer and whose contribution to the
greenhouse effect is virtually zero.

Installation

WARNING: Correct installation of
your device complying with the rules that
are given in this installation guide and use
will allow you to keep your food in good
conditions and with optimized energy
consumption.
If your appliance has wheels, remember
·
that they are only used to facilitate small
movements. Do not move on longer
distance.
Make an initial cleaning before
·
connecting your device to the mains.
Before any maintenance, disconnect your
device. Do not pull the power cord but
directly enter the profile.
Place the unit in a dry and ventilated
·
room.
Avoid balconies, porches, decks;
·
excessive heat in summer and cold in
winter could prevent proper operation of
your device, or even damage.
Do not place it near a heat source such
·
as radiator or oven for example.
Keep a minimum distance between your
·
refrigerator and other furniture: 3 to 5 cm
on the sides and 10 cm above for good
air circulation around the unit.
Place the appliance at a suitable
·
distance from the wall using the spacers if
they provided in the accessory bag.
Your appliance has been designed for
·
optimum performance in a room
temperature. We then say that it is
designed for a special "climate class".
This climate class is clearly stated on the
rating plate located inside your appliance,
on the left wall down. Beyond these
temperatures, the performance of your
appliance may be reduced.
Classe
Temperature
SN
from + 10°C to + 32°C
N
from + 16°C to + 32°C
ST
from + 16°C to + 38°C
T
from + 16°C to + 43°C
Advice:
After installation of your appliance, set its
feet so that it is slightly tilted backwards, it
will facilitate the closing of the door.
Before putting food, clean the interior and
exterior of your appliance with bicarbonate
of soda dissolved in water (1 tablespoon of
bicarbonate for 4 litres of water). Do not
use alcohol, abrasive powders or
detergents which could damage the
surfaces. (See chapter "Cleaning your
appliance").
ELECTRICAL CONNECTION
The electrical installation must comply
with the applicable standards and must be
able to withstand the maximum power
indicated on the rating plate.
The plug must be properly grounded.
We cannot be held responsible for any
incident caused by defective electrical
installation.
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bfu584ynx

Table of Contents