Connection; How To Use The Pc Card Slot - Toshiba TDP TDP-SW20 Owner's Manual

Connection

Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Audio amplifier, etc.
To audio input To RS-232C terminal
White (L)/Red (R)
Audio cable
(not supplied)
Audio cable
RGB cable
(not supplied)
(supplied)
Monitor cable Mini
D-sub 15P-BNC
To RGB To audio (not supplied)
output output
Computer DVD video recorder, etc.
Notes
• COMPUTER terminals 1 and 2 function identically.
• The AUDIO IN terminal doubles for devices connected to COMPUTER terminals 1 and 2.
p.69 , etc.
Computer
(for control)
Video recorder,
DVD player, etc.
To audio output
p.71
White (L)/Red (R)
Video cable
Control cable (not supplied)
CONTROL
S-VIDEO
MONITOR AUDIO OUT
R L
VIDEO
COMPUTER 2 IN COMPUTER 1 IN
( ) ( )
Y/P B /P R AUDIO IN Y/P B /P R
RGB cable
AV cable
(not supplied)
(not supplied)
To audio output
White (L)/
Red (R)
Audio cable
(not supplied)
To audio
To RGB
VCR
output
output
To Y/C /C output
B R
Green (Y)/Blue (C )/Red (C )
B R
Conversion adapter BNC-pin
(not supplied)
Computer
20

How to use the PC card slot

The wireless LAN PC card enables you to connect the projector wirelessly with a personal
computer that supports IEEE802.11b based wireless LAN.
nication between all the computers based on IEEE802.11b and this projector is not
guaranteed.) You can also use a commercially available memory card to project JPEG
image files using this projector.
mounting a PC card.
■ Mounting a PC card
q Remove the PC card slot cover.
Press lightly on the circle ("O") while
sliding the cover in the direction of the
arrow.
To S-Video
output
S-Video cable
Card slot cover
(not supplied)
w Insert the PC card.
After making sure of the card orienta-
tion, press it in firmly until it stops.
To video
output
■ If CARD indicator turns red
Press the RESET switch with a thin pin or
similar implement (it is at the bottom of a
recess).
(Please note that commu-
p.34
p.41 Please follow the steps below when removing or
■ Removing a PC card
q Look at CARD indicator.
If it is off, proceed to step r.
CARD indicator
UNMOUNT button
w Press the UNMOUNT button.
Begins processing for PC card removal.
e Wait until CARD indicator goes
out.
Never remove the PC card while lit.
Doing so could damage the PC card or
corrupt your data.
r Press the Eject button.
PC Card
The Eject button is a bit stiff, so
press firmly while supporting the
projector. Be careful to avoid injury
when doing so.
CARD indicator
RESET switch
21
Eject button