Sharp KS-M102 Service Manual page 14

CAUTION
When assembling, be sure not to catch the lead wires for the inner lid heater.
As shown in Fig. 6, the lead wires of the lid heater are to be passed under the rib of the lid cover
and passed above the hinge pin.
After assembly, make sure not to have deformation of inner lid packing. Otherwise, it may cause
steam leakage.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect all lead wires of heater plate from the PCB ass'y. (Fig. 7.)
3. The heater plate ass'y comes off by removing 3 screws. (Fig. 7.)
4. Now the heater plate ass'y is free.
CAUTION
The inner pot should be in the position to prevent the heater plate from falling when removing 3 screws.
Lead wire
REMOVE OF HEATER PLATE ASS'Y
Thermistor fixing tab
1
2
3
4
5
6
7
Lead wires of lid heater
Fig. 6.
Heater plate fixing screws
Inner lid lead wire connector
14
Fig. 7.